|
Halson Radio
10-05-2016, 03:29 PM
1. the 460ohm resistor the original was a flex resistor that was open. I found a section that had continuity and measured it then calculated that this is what it should be for the length, not sure if I'm right. 2 Vol pot was not original and was burned up I have used a 30k also with out any difference. Currently a 10k is this ok? 3 All the G2 pin 3 are tied in series If I attach my ant to G1 of the 24A it plays great lots of stations. What now? Eric
« Next Oldest | Next Newest »
Messages In This Thread
Halson Radio - by Eric - 10-03-2016, 09:05 AM
RE: Halson Radio - by morzh - 10-03-2016, 10:37 AM
RE: Halson Radio - by Eric - 10-03-2016, 02:49 PM
RE: Halson Radio - by morzh - 10-03-2016, 04:16 PM
RE: Halson Radio - by Eric - 10-03-2016, 06:39 PM
RE: Halson Radio - by KCMike - 10-03-2016, 04:49 PM
RE: Halson Radio - by Eric - 10-03-2016, 06:38 PM
RE: Halson Radio - by Radioroslyn - 10-03-2016, 06:27 PM
RE: Halson Radio - by Kenneth F. Besso Jr. - 10-03-2016, 08:02 PM
RE: Halson Radio - by morzh - 10-03-2016, 08:32 PM
RE: Halson Radio - by Arran - 10-04-2016, 02:38 AM
RE: Halson Radio - by morzh - 10-04-2016, 06:58 AM
RE: Halson Radio - by OldRestorer - 10-04-2016, 07:58 AM
RE: Halson Radio - by morzh - 10-04-2016, 11:38 AM
RE: Halson Radio - by Eric - 10-04-2016, 01:36 PM
RE: Halson Radio - by Eric - 10-05-2016, 03:29 PM
RE: Halson Radio - by Radioroslyn - 10-05-2016, 04:58 PM
RE: Halson Radio - by Eric - 10-06-2016, 04:48 PM
RE: Halson Radio - by Radioroslyn - 10-06-2016, 05:22 PM
RE: Halson Radio - by Eric - 10-07-2016, 12:28 PM
RE: Halson Radio - by Radioroslyn - 10-07-2016, 12:54 PM
RE: Halson Radio - by TA Forbes - 10-07-2016, 07:51 PM
RE: Halson Radio - by Arran - 10-11-2016, 03:20 AM
Users browsing this thread: 1 Guest(s) |
