1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 60 tuning shaft slips
black85vette
Junior Member
**
Posts: 9
Threads: 3
Joined: Mar 2016
City: Yukon, OK USA 73099
#8

01-10-2017, 08:20 AM
Another bit that puzzles me. The tuning cap is isolated by the rubber feet, but then has a ground strap soldered to the rear mounting screw by a braided ground strap directly to the chassis. This is a very awkward setup. You have a screw that has solder all over the top making it difficult to remove. Why not just ground the frame of the cap to the chassis directly? I am thinking of putting aluminum or brass spacers under the cap. Is there a valid reason to shock mount the tuning cap??
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 60 tuning shaft slips - by black85vette - 01-09-2017, 01:42 PM
RE: Philco 60 tuning shaft slips - by klondike98 - 01-09-2017, 01:57 PM
RE: Philco 60 tuning shaft slips - by morzh - 01-09-2017, 02:18 PM
RE: Philco 60 tuning shaft slips - by morzh - 01-09-2017, 02:48 PM
RE: Philco 60 tuning shaft slips - by morzh - 01-09-2017, 11:27 PM
RE: Philco 60 tuning shaft slips - by black85vette - 01-10-2017, 08:20 AM
RE: Philco 60 tuning shaft slips - by morzh - 01-10-2017, 08:23 AM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration