|
Re-Stuffing Canned Electrolytics - Part 64000
03-23-2017, 08:30 AM
(03-22-2017, 09:16 PM)KCMike Wrote: Hello. Many ways to do this operation. I have did what you have but found securing a large lag bolt to vice and screwing the can after its cut open onto the bolt. Then a little heat from Bernzomatic torch it will pull the can right off. Thanks KCMike - I KNEW there was an easier way because the way I did it was not easy at all ;) Rich
« Next Oldest | Next Newest »
Messages In This Thread
Re-Stuffing Canned Electrolytics - Part 64000 - by criageek - 03-22-2017, 08:33 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by criageek - 03-22-2017, 08:41 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by KCMike - 03-22-2017, 09:16 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by criageek - 03-23-2017, 08:30 AM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by Dennis Craft - 03-22-2017, 10:16 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by Mondial - 03-23-2017, 09:05 AM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by criageek - 03-26-2017, 06:52 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by jcassity - 03-31-2017, 02:49 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by criageek - 03-31-2017, 06:04 PM
RE: Re-Stuffing Canned Electrolytics - Part 64000 - by jcassity - 04-01-2017, 10:12 AM
Users browsing this thread: 1 Guest(s) |
