Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 52 voltage issue
#2

Hi Pear and Welcome,
Sounds like #1 ( 1/2 of the volume control) or #34 is open. Simple test is measure the resistance from the cathode to chassis gnd, should see with volume control full up abt 250 ohm. Set unplugged of course.
http://www.philcoradio.com/images/phorum/schem/51.jpg

GL
ps Didn't read your full post to answer your question Yes it's a very good possibility. Under normal conditions a shorted tube wouldn't deliver HV to the cathode w/o either showing a low plate voltage or smoking the cathode resistor. In your case the cathode circuit is open.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Model 52 voltage issue - by Pear - 06-24-2017, 10:49 AM
RE: Model 52 voltage issue - by Radioroslyn - 06-24-2017, 12:09 PM
RE: Model 52 voltage issue - by klondike98 - 06-24-2017, 12:25 PM
RE: Model 52 voltage issue - by Pear - 06-25-2017, 02:10 PM
RE: Model 52 voltage issue - by Arran - 06-25-2017, 03:08 PM



Users browsing this thread: 1 Guest(s)