07-28-2017, 11:38 PM
Tested tubes and half were pretty weak. Recapped soldered new ecaps under chassis
rather than restuffing as they are difficult to remove. Push button assy has to come out remove them. Original off/on switch is bad so am sourcing a replacement. Output transformer is open but have a suitable replacement on hand. Wiring is pretty good but need to rewire the lamps and replace insulators. Maybe this afternoon I can give it a try.
rather than restuffing as they are difficult to remove. Push button assy has to come out remove them. Original off/on switch is bad so am sourcing a replacement. Output transformer is open but have a suitable replacement on hand. Wiring is pretty good but need to rewire the lamps and replace insulators. Maybe this afternoon I can give it a try.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
