|
38-1 121A run2 #4
08-30-2017, 05:37 PM
If someone has slobbed shellac over the original lacquer finish then alcohol should remove it, either ethyl or isopropyl alcohol, without damaging the original finish. If the dial is similar to a 116 series set then there should be a locking ring that holds the dial on it's hub, sort of a flat disk with two tabs sticking out, give it a 1/4 turn and it and the dial should come off.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
38-1 121A run2 #4 - by Electrothaumaturgist - 08-28-2017, 06:57 PM
RE: 38-1 121A run2 #4 - by morzh - 08-28-2017, 07:50 PM
RE: 38-1 121A run2 #4 - by Electrothaumaturgist - 08-28-2017, 08:16 PM
RE: 38-1 121A run2 #4 - by Radioroslyn - 08-28-2017, 08:28 PM
RE: 38-1 121A run2 #4 - by Electrothaumaturgist - 08-28-2017, 09:12 PM
RE: 38-1 121A run2 #4 - by morzh - 08-29-2017, 06:53 AM
RE: 38-1 121A run2 #4 - by Radioroslyn - 08-29-2017, 09:21 AM
RE: 38-1 121A run2 #4 - by morzh - 08-29-2017, 12:14 PM
RE: 38-1 121A run2 #4 - by Arran - 08-30-2017, 05:37 PM
RE: 38-1 121A run2 #4 - by Electrothaumaturgist - 03-05-2018, 11:30 PM
Users browsing this thread: 1 Guest(s) |
