|
To re-wire or not to re-wire....
09-08-2017, 08:52 PM
If there is exposed chassis, I change to a polarized cord and run the hot wire to the switch and then back to the rectifier tube. I run this loop side by side and twist the wires together to minimize magnetic radiation. I try to run them around the corners of the chassis away from any audio tubes. I have never had a hum issue this way. Any line bypass caps get Y2 safety caps.
Rob
« Next Oldest | Next Newest »
Messages In This Thread
To re-wire or not to re-wire.... - by Greenhorn - 09-08-2017, 12:53 PM
RE: To re-wire or not to re-wire.... - by WallaceRoger - 09-08-2017, 01:15 PM
RE: To re-wire or not to re-wire.... - by morzh - 09-08-2017, 01:18 PM
RE: To re-wire or not to re-wire.... - by Radioroslyn - 09-08-2017, 04:36 PM
RE: To re-wire or not to re-wire.... - by Greenhorn - 09-08-2017, 06:17 PM
RE: To re-wire or not to re-wire.... - by morzh - 09-08-2017, 06:39 PM
RE: To re-wire or not to re-wire.... - by robsradioactive - 09-08-2017, 08:52 PM
RE: To re-wire or not to re-wire.... - by Arran - 09-10-2017, 08:38 PM
RE: To re-wire or not to re-wire.... - by Greenhorn - 09-11-2017, 04:13 PM
RE: To re-wire or not to re-wire.... - by byoungblood - 10-25-2017, 12:35 PM
Users browsing this thread: 1 Guest(s) |
