10-29-2017, 01:07 PM
Hi Scott and welcome,
Looks like the only thing that was done was the original electrolytics were disconnected and new one ere added. Caps in the blocks are original. For starters I would restuff the electrolytics into the original cans and rebuild the blocks. Check resistors and replace one that are out of tolerance. Test for weak tubes, replace tuning cap rubber mounts (if worn), remove cln and grease the two speed dial drive, align with a signal generator, and enjoy.
Looks like the only thing that was done was the original electrolytics were disconnected and new one ere added. Caps in the blocks are original. For starters I would restuff the electrolytics into the original cans and rebuild the blocks. Check resistors and replace one that are out of tolerance. Test for weak tubes, replace tuning cap rubber mounts (if worn), remove cln and grease the two speed dial drive, align with a signal generator, and enjoy.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
