02-15-2018, 03:27 PM
If you can strip away the paper near the broken connection and solder it back together that would be the easy way to go. The red wire is connected to the hv (100vdc or so ) and the blue connects the the plate pin of the output tube. These two leads would be considered the primary and the other two are the secondary.
If you can't reattach the wire the replacement part would match a 2000 ohm load to a 4 ohm spkr.
http://www.radiodaze.com/all-american-fi...io-output/
If you can't reattach the wire the replacement part would match a 2000 ohm load to a 4 ohm spkr.
http://www.radiodaze.com/all-american-fi...io-output/
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
