01-21-2019, 07:03 PM
I am just finishing up a restoration on a really nice 37-650X console. I all ready have a half dozen GO To radios for short wave listening so I would like to configure this radio to play my RCA 45rpm record player/changer. Specifically a 45-J-2 I recently refurbed. I have spent quite a bit of time researching this but have more questions now than I did before I started.
So my thoughts are to cut the wire between C40 and the junction to the left of it and install a SPDT switch to switch between radio and phono. Input record player input at top of C40. Should I put a .01 cap in series with phono input? Should I put another switch to remove ant input?
Any help would be appreciated. Like I said this is a beautiful radio and I don't want it to sit around gathering dust. I have a BC-348Q, SX-100 and Sx-99 and several others for shortwave listening so I really don't need another SW radio.
Thank you very much for your time
KK4KRU
Schematic
So my thoughts are to cut the wire between C40 and the junction to the left of it and install a SPDT switch to switch between radio and phono. Input record player input at top of C40. Should I put a .01 cap in series with phono input? Should I put another switch to remove ant input?
Any help would be appreciated. Like I said this is a beautiful radio and I don't want it to sit around gathering dust. I have a BC-348Q, SX-100 and Sx-99 and several others for shortwave listening so I really don't need another SW radio.
Thank you very much for your time
KK4KRU
Schematic
