Got the amp working easy enough and sounds pretty decent- https://www.youtube.com/watch?v=bEtvu4ldFts but didn't have a lot of hope for the original motor after retensioning the brushes still not able to get continuity and the commutator looked burned, so decided to repower with a Mabuchi RC280 RC car motor, turns out these are just a purrfect 24MM diameter case and 2.0mm shaft size compared to the original-
The resulting speed achieved was ~22-1/2 RPM
so I thought about it for a day or two while I have been waiting for a couple other motor choices, ~$2-$3 free shipping from China!
But tonight I thought about ways to increase the speed with a sleeve over the motor shaft and picked a piece of PVC ~18ga wire insulation which got me close to the right speed, but adding a piece of shrink tubing over that made it just about the right speed at the top of the range
https://www.youtube.com/watch?v=85gdEytzZac The case cleaned up quite a bit with my favorite lanolin hand cleaner, a nice brush and a moist rag.
PWM controller and lower voltage motors coming soon, this one was advertised as "3, 6, 9, 12V . . . " 17,000 rpm . . .YMMV
The resulting speed achieved was ~22-1/2 RPM
so I thought about it for a day or two while I have been waiting for a couple other motor choices, ~$2-$3 free shipping from China! But tonight I thought about ways to increase the speed with a sleeve over the motor shaft and picked a piece of PVC ~18ga wire insulation which got me close to the right speed, but adding a piece of shrink tubing over that made it just about the right speed at the top of the range
https://www.youtube.com/watch?v=85gdEytzZac The case cleaned up quite a bit with my favorite lanolin hand cleaner, a nice brush and a moist rag.PWM controller and lower voltage motors coming soon, this one was advertised as "3, 6, 9, 12V . . . " 17,000 rpm . . .YMMV
