Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Replacing Rubber Wire
#15

Nice job, Steve. Might I add that collecting mostly 1930-1938 radios (me) means that I have fewer cases such as this where it is tight spaces with a lot going on. UNFORTUNATELY the rf deck of the Philco 37-___ and 38-___ radios will add pure joy in a really BAD way. I have a 37-670 tombstone that drives me nuts when I listen to it (loses volume/shadowmeter blacks out) and I have put off working on it because I KNOW it will eventually lead me to the d**d rf deck.

The first Airline that I have really "messed" with is a 62-196 tombstone that I am currently finishing. On this model,anyway, I found the overall layout including what at first appeared to be a complicated dial system, to be well laid out and "repairable." I did NOT care for the "dual" volume pot configuration, but did especially like the way they laid out the chassis underside. BZ !!!

It recieves well and sounds great for a 7 tube radio with a relatively cheap 6" speaker.


Messages In This Thread
Replacing Rubber Wire - by jjbuzard - 11-27-2009, 03:26 PM
Re: Replacing Rubber Wire - by codefox1 - 11-27-2009, 04:38 PM
Re: Replacing Rubber Wire - by jjbuzard - 11-30-2009, 11:04 AM
Re: Replacing Rubber Wire - by gary rabbitt - 12-22-2009, 02:52 AM
Re: Replacing Rubber Wire - by FStephenMasek - 12-31-2009, 01:05 AM
Re: Replacing Rubber Wire - by Ron Ramirez - 12-31-2009, 09:33 AM
Re: Replacing Rubber Wire - by Sean - 12-31-2009, 03:58 PM
Re: Replacing Rubber Wire - by Guest - 01-16-2010, 11:54 AM
Re: Replacing Rubber Wire - by exray - 01-16-2010, 10:01 PM
Re: Replacing Rubber Wire - by Joe Rossi - 01-17-2010, 11:28 AM
Re: Replacing Rubber Wire - by Ron Ramirez - 01-17-2010, 07:49 PM
Re: Replacing Rubber Wire - by codefox1 - 01-18-2010, 03:07 AM
Re: Replacing Rubber Wire - by MinnesotaHam - 01-18-2010, 06:40 PM
Re: Replacing Rubber Wire - by FStephenMasek - 12-22-2010, 09:28 PM
Re: Replacing Rubber Wire - by TA Forbes - 12-22-2010, 10:10 PM



Users browsing this thread: 1 Guest(s)