01-25-2020, 02:58 PM
I am working on a Philco model 80 and am looking for a non metallic nut driver to align the four adjustments on the rear of the chassis and the two on the tuning capacitor. Any idea where one can be obtained?
|
Tuning Tool Availability
« Next Oldest | Next Newest »
Messages In This Thread
Tuning Tool Availability - by Jimmiek - 01-25-2020, 02:58 PM
RE: Tuning Tool Availability - by Stall-U-Rated - 01-25-2020, 03:19 PM
RE: Tuning Tool Availability - by Nathan Slingerland - 01-25-2020, 04:16 PM
RE: Tuning Tool Availability - by klondike98 - 01-25-2020, 06:18 PM
RE: Tuning Tool Availability - by Jimmiek - 01-25-2020, 08:47 PM
RE: Tuning Tool Availability - by klondike98 - 01-26-2020, 12:35 PM
RE: Tuning Tool Availability - by captainclock1988 - 01-27-2020, 07:44 PM
RE: Tuning Tool Availability - by morzh - 01-27-2020, 09:44 PM
RE: Tuning Tool Availability - by captainclock1988 - 01-27-2020, 10:11 PM
RE: Tuning Tool Availability - by rfeenstra - 01-27-2020, 10:39 PM
RE: Tuning Tool Availability - by morzh - 01-28-2020, 11:00 AM
Users browsing this thread: 1 Guest(s) |
