06-12-2020, 02:10 PM
Learning as I go on my first project.
I glued the side of this rescued 46-1209 where the veneer had separated. A few days later, the bubble you see in the photo appeared. I read online that I can either make a thin slit and reapply glue with a syringe, or use an iron and damp cloth. Any recommendations for this first-timer?
Also visible in the photo is where the black rubber trim/strip broke off. What is a good replacement? And does the top "ridge" also need a piece? There is nothing there (or on the other side) currently -- not sure if it's supposed to be like that or if the piece is missing completely.
Thank you!
I glued the side of this rescued 46-1209 where the veneer had separated. A few days later, the bubble you see in the photo appeared. I read online that I can either make a thin slit and reapply glue with a syringe, or use an iron and damp cloth. Any recommendations for this first-timer?
Also visible in the photo is where the black rubber trim/strip broke off. What is a good replacement? And does the top "ridge" also need a piece? There is nothing there (or on the other side) currently -- not sure if it's supposed to be like that or if the piece is missing completely.
Thank you!
