|
Philco 66 Plate Voltages Too High
05-16-2022, 03:00 PM
Thank you for the reply gentlemen. I should have mentioned that I did consider the potential impact of meter impedance so I tested with a standard VOM, a VTVM and a Fluke Scopemeter and all three measured within a couple volts, and yes all of these meters are nowhere near 1000 ohms/volt. I'm still torn as to whether I should let it run as-is or use a solution to throttle it back.
Jim
« Next Oldest | Next Newest »
Messages In This Thread
Philco 66 Plate Voltages Too High - by JimSirt - 05-15-2022, 09:14 PM
RE: Philco 66 Plate Voltages Too High - by klondike98 - 05-16-2022, 12:09 PM
RE: Philco 66 Plate Voltages Too High - by Ron Ramirez - 05-16-2022, 01:24 PM
RE: Philco 66 Plate Voltages Too High - by JimSirt - 05-16-2022, 03:00 PM
Users browsing this thread: 1 Guest(s) |
