1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 17 SW band not working
boxjoint
Junior Member
**
Posts: 27
Threads: 3
Joined: Apr 2019
City: Miami State, Province, Country: Florida
#1

09-10-2022, 02:42 PM
I am restoring a Philco 17 and I have already recapped the whole radio.  The broadcast band is working fine however the SW band is not working.  I have cleaned the band switch thoroughly and I tried to inject a 1600 khz signal but did not get a tone.  I believe that I should be gettting low ohms from the antenna jack to ground and even lower when the band switch is in the SW position but I get 36 ohms with the switch in both positions.  Please see the schematic I have attached.  Any help would be greatly appreciated.

-Carlos

   
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 17 SW band not working - by boxjoint - 09-10-2022, 02:42 PM
RE: Philco 17 SW band not working - by boxjoint - 09-10-2022, 09:01 PM
RE: Philco 17 SW band not working - by boxjoint - 09-10-2022, 10:38 PM
RE: Philco 17 SW band not working - by boxjoint - 09-11-2022, 03:47 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration