10-10-2022, 05:11 PM
http://pacifictv.ca/schematics/philco38-c7manual.pdf
I was cleaning the chassis on a Philco 38-C9. It was obviously in a home with heavy smokers, very heavy grime on everything. I then was cleaning the part in the photo that held the shadowmeter, scrapped off some of the yellow fuzzy stuff…stopped and realized it may supposed to be there. I already removed the fuzz from the other side of the part in the photo.
Did I mess something up, and if I did is there any way to rectify the situation? I’m new to this and have never seen anything like this fuzz before.
Any advice would be greatly appreciated.
I was cleaning the chassis on a Philco 38-C9. It was obviously in a home with heavy smokers, very heavy grime on everything. I then was cleaning the part in the photo that held the shadowmeter, scrapped off some of the yellow fuzzy stuff…stopped and realized it may supposed to be there. I already removed the fuzz from the other side of the part in the photo.
Did I mess something up, and if I did is there any way to rectify the situation? I’m new to this and have never seen anything like this fuzz before.
Any advice would be greatly appreciated.
