03-23-2023, 09:41 PM
Thanks again for the help!
Those two CAPS-to-Chassis puzzled me but I figured as long as I didn't hold the chassis in one hand and poke the Rectifier plate/tabs with a finger from my other hand then I was "safe"...or have I just been lucky that I wasn't grounded when holding the chassis?
I noticed the filaments were "glowing" and didn't know if that would cause problems so that's why I unsoldered that line.
Yes, I identified an O-ring via Amazon.com that should fit that Idler Wheel (rim); just haven't ordered it yet. The weather has been favorable so I've been working on the cabinets lately.
Those two CAPS-to-Chassis puzzled me but I figured as long as I didn't hold the chassis in one hand and poke the Rectifier plate/tabs with a finger from my other hand then I was "safe"...or have I just been lucky that I wasn't grounded when holding the chassis?
I noticed the filaments were "glowing" and didn't know if that would cause problems so that's why I unsoldered that line.
Yes, I identified an O-ring via Amazon.com that should fit that Idler Wheel (rim); just haven't ordered it yet. The weather has been favorable so I've been working on the cabinets lately.
