04-08-2012, 10:18 AM
Happy Easter to all!!
I recently acquired an Admiral/Continental 960 8K. The set had 99%recapped and I did the last one. The volume control had been replaced with an IRC control. Seems that when the set is turned on I can only move the volume control a tiny bit and the increase in volume is huge.
This is a combo on/off and volume switch. The shaft had been cut a tad short so I got out my IRC book and found that I have a new control. There is a difference however between the new one I have and the one that was in the set. The new one has the three tabs on the top and one tab on the bottom of the control. What was in the set had no bottom tab.
I am wondering if the pot is wired incorrectly. Here is a link to the schematic and two pics of the control. Any input would be appreciated.
http://www.nostalgiaair.org/PagesByModel...003040.pdf
[Image: http://i1185.photobucket.com/albums/z345...volume.jpg]
[Image: http://i1185.photobucket.com/albums/z345...olume2.jpg]
Gene
I recently acquired an Admiral/Continental 960 8K. The set had 99%recapped and I did the last one. The volume control had been replaced with an IRC control. Seems that when the set is turned on I can only move the volume control a tiny bit and the increase in volume is huge.
This is a combo on/off and volume switch. The shaft had been cut a tad short so I got out my IRC book and found that I have a new control. There is a difference however between the new one I have and the one that was in the set. The new one has the three tabs on the top and one tab on the bottom of the control. What was in the set had no bottom tab.
I am wondering if the pot is wired incorrectly. Here is a link to the schematic and two pics of the control. Any input would be appreciated.
http://www.nostalgiaair.org/PagesByModel...003040.pdf
[Image: http://i1185.photobucket.com/albums/z345...volume.jpg]
[Image: http://i1185.photobucket.com/albums/z345...olume2.jpg]
Gene
