|
Philco 40-180 push button labels
11-27-2012, 11:33 AM
I just finished restoring a Philco 40-180. Now I must put station identifiers where presently only holes exist above each pushbutton. Pictures of other restored 40-180's seem to show the station callsigns attached behind the bezel. Is that the way the factory did it? If installed from the front, what did they use to hold them in place? Joe
jdgatto@earthlink.net
« Next Oldest | Next Newest »
Messages In This Thread
Philco 40-180 push button labels - by joegatto - 11-27-2012, 11:33 AM
RE: Philco 40-180 push button labels - by codefox1 - 11-27-2012, 02:54 PM
RE: Philco 40-180 push button labels - by joegatto - 11-27-2012, 04:24 PM
RE: Philco 40-180 push button labels - by Art Hoch - 11-27-2012, 06:30 PM
RE: Philco 40-180 push button labels - by joegatto - 11-27-2012, 06:38 PM
RE: Philco 40-180 push button labels - by rocketeer - 11-28-2012, 09:04 PM
RE: Philco 40-180 push button labels - by joegatto - 11-29-2012, 08:13 AM
RE: Philco 40-180 push button labels - by gary rabbitt - 11-29-2012, 09:50 PM
RE: Philco 40-180 push button labels - by joegatto - 11-30-2012, 08:08 AM
RE: Philco 40-180 push button labels - by gary rabbitt - 12-02-2012, 01:09 PM
RE: Philco 40-180 push button labels - by amack31 - 07-21-2018, 09:09 PM
RE: Philco 40-180 push button labels - by PhilcoPhan1936 - 07-22-2018, 01:05 AM
RE: Philco 40-180 push button labels - by Ron Ramirez - 07-22-2018, 06:08 AM
RE: Philco 40-180 push button labels - by PhilcoPhan1936 - 07-23-2018, 11:25 AM
RE: Philco 40-180 push button labels - by fwmartin2000 - 02-09-2020, 10:05 PM
Users browsing this thread: 1 Guest(s) |
