1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Candohm replacement
klondike98
Phorum Moderator
******
Posts: 5,018
Threads: 267
Joined: Nov 2012
City: Bandon State, Province, Country: OR
#10

01-17-2013, 11:50 AM
Thanks BrendaAnnD.

a) 35Z3 cathode is -1vDC
b) 35Z3 plate is 108vAC (line is 110vAC through isolation xfmr)
c) both in and out of field coil are -1vDC
d) B- common is same wire as original wire (but heat shrink covered to replace old rubber) and has continuity to other B- points
e) dial lamp is working (now that candohm was replaced with some power resistors http://philcoradio.com/phorum/showthread.php?tid=5697 )

Regards,
bob
Cheers,
Bob
[Image: https://www.dropbox.com/s/5m63ib99yfx2eg....jpg?raw=1]
Bob's Restorations Web Page
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Candohm replacement - by klondike98 - 01-05-2013, 03:33 PM
RE: Candohm replacement - by codefox1 - 01-05-2013, 04:04 PM
RE: Candohm replacement - by morzh - 01-05-2013, 05:10 PM
RE: Candohm replacement - by klondike98 - 01-05-2013, 05:39 PM
RE: Candohm replacement - by Arran - 01-05-2013, 09:35 PM
RE: Candohm replacement - by Phlogiston - 01-05-2013, 10:26 PM
RE: Candohm replacement - by klondike98 - 01-06-2013, 01:57 PM
RE: Electrolytic cap polarity question/advice - by klondike98 - 01-17-2013, 11:50 AM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration