|
48-1262
10-08-2013, 03:05 PM
If the external aerial lug in the diagram is connected to the chassis for loop antenna operation then R400 will read as 0 ohms since both ends terminate to the chassis. You can not always measure the resistance while the resistor is still in the circuit. If there is an alternate path for DC current to flow around the resistor you will get a faulty reading.
« Next Oldest | Next Newest »
Messages In This Thread
RE: 48-1262 - by klondike98 - 10-08-2013, 03:05 PM
RE: 48-1262 - by BrendaAnnD - 10-08-2013, 03:09 PM
RE: 48-1262 - by ke5yum - 10-09-2013, 06:42 AM
RE: 48-1262 - by ke5yum - 10-22-2013, 06:56 AM
RE: 48-1262 - by Radioroslyn - 10-22-2013, 05:05 PM
RE: 48-1262 - by Radioroslyn - 10-22-2013, 05:48 PM
RE: 48-1262 - by ke5yum - 10-23-2013, 07:05 AM
RE: 48-1262 - by ke5yum - 10-30-2013, 06:57 AM
RE: 48-1262 - by Radioroslyn - 10-30-2013, 07:15 PM
RE: 48-1262 - by ke5yum - 10-31-2013, 07:02 AM
RE: 48-1262 - by Radioroslyn - 10-31-2013, 03:53 PM
RE: 48-1262 - by ke5yum - 11-01-2013, 06:50 AM
RE: 48-1262 - by ke5yum - 12-13-2013, 08:16 AM
RE: 48-1262 - by Radioroslyn - 12-15-2013, 12:08 PM
RE: 48-1262 - by ke5yum - 12-18-2013, 08:37 AM
RE: 48-1262 - by klondike98 - 12-18-2013, 09:03 AM
Users browsing this thread: 1 Guest(s) |
