12-28-2013, 01:39 PM
Looking at the 12/350 electrolitic, and there are a few wires soldered to the mounting nut for the can.
There is what looks like a noncumductive washer under the nut.
There is a red wire soldered on the nut which has 13.5 volts going thru it from a terminal strip close by as well as a green wire(I think its green) from the transformer. There is also a resistor mounted to this nut which goes up to a terminal strip.
Is this just a tie point for the wires or do they need to be connected to the negative side of the new electrolitic.
Kind of confused on this one?
murf
There is what looks like a noncumductive washer under the nut.
There is a red wire soldered on the nut which has 13.5 volts going thru it from a terminal strip close by as well as a green wire(I think its green) from the transformer. There is also a resistor mounted to this nut which goes up to a terminal strip.
Is this just a tie point for the wires or do they need to be connected to the negative side of the new electrolitic.
Kind of confused on this one?
murf
