12-31-2017, 08:25 PM
One thing is for sure, those dials are NOT cheap, so some felt may not be a bad idea. Thanks for the suggestion Ron! I think it is easy to bend those tabs while working on a chassis without even knowing it. I am sure this happened in a previous repair. It's something to watch for at least.
I did an alignment attempt last night. I didn't see a real day or night difference other than I think I had the dial off position a little bit. I may need to move it and touch up. May not make a difference either. I set the dial by tuning in a station that I knew the location. Anyway, I may leave it alone unless there are reasons to reset.
I did an alignment attempt last night. I didn't see a real day or night difference other than I think I had the dial off position a little bit. I may need to move it and touch up. May not make a difference either. I set the dial by tuning in a station that I knew the location. Anyway, I may leave it alone unless there are reasons to reset.
If I could find the place called "Somewhere", I could find "Anything"
Tim
Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
