Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Looking for TV console model #
#1

Hi,
First time on the Phorum.
I recently acquired a Philco tv, record player, radio console. I followed all the suggestions on the Philco site as to how to identify the model #.  There is no Philco tag on the cabinet, and no chassis # stamped on any of the components.  The tube layout guide is also gone. I did the best I could with a Sam's Photofact #123 which puts the console # at 51-T1443 PL but it's just barely not right. 
The first problem I have is that it's missing a tube. The schematic for the RF-IF tuner shows a 6CB6 tube, but on the chassis there is a 9 pin socket, which means I have the wrong schematic. 
So... I'm trying to find the console model # , so I can get the correct schematic,  so I can get the correct tube. The back of the tuner just has RF 35 rubber stamped,  and RUN 6.
I've been searching that #, and no results. I have pics of the console, and found one on the internet that looks like an exact match, but still no mod #. And adding pics here is a little tricky. 
Any ideas how to find a mod # with no markings on the unit ?
Thanks,
Chris.
           
#2

Hi and welcome.

Is the other tube a 12AV7? If so looks like the missing tube is a 6BQ7.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Thanks Terry ,
You are correct. The tube next to it is a 12AV7. Not sure how you onew that, but you have skills !
I appreciate the help.
I ordered one and will try it out.
Chris.

Still looking for that model # or how to find it.
#4

Duplicated post of #3. Deleted second post.

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3905 online users. [Complete List]
» 1 Member(s) | 3904 Guest(s)
Avatar

>