Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Vibrator For Zenith 6V27 ?
#1

I started working on a Zenith 6V27, a 6 volt farm set. Lucky me, all the shields were on the set, but two of the # 15 tubes weren't in the set... Working on finding one through friends. BUT it looks like I will have to replace the vibrator, which is a Zenith part # 190-6V (a 6 pin synchronous type - 6 volt). Searching Google threads, I say someone mention that the Mallory 256 or 1808/4546 would be a good replacement. Where in the world, or rather who in the world sells vibrators? (Please don't flame me!). I'm already cross-eyed from searching and I sure could use some help.

Thanks!
David
#2

BUICK, used a synchronous vibrator, there are some transistorised vibrators being made for vintage auto radios, they are $$$. You could use a four pin vibrator and use diodes for rectifier. Have you tried buzzing your vibrator on AC ? You do it in line with a 40 watt light bulb
#3

Thanks, I'll try that




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently no members online.

>