Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sweep Generator?
#1

OK, more questions.
To align FM radios do I have to have a sweep generator? Can it be done with an RF generator?

If I need one, is this what I want? :http://www.ebay.com/itm/BK-Precision-302...232ae274b1

Thanks

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

#2

It depends on the receiver. Some manufacturers specify a sweep alignment with a sweep generator and scope, others just use a simple peaking procedure and zero setting the discriminator output with an on frequency IF signal from a usual RF generator.

A lot depends if the IF transformers are overcoupled for wide bandwidth. Although I have a couple of sweep generators, I have usually been able to do a pretty fair job without using them for FM receiver alignment.

The generator on ebay won't work for aligning a broadcast FM receiver. It is a low frequency sweep/function generator and only goes up to 2 MHz. You need a 10.7 MHz sweep signal.
#3

Thanks. I'm glad I asked.

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org





Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 3517 online users. [Complete List]
» 2 Member(s) | 3515 Guest(s)
AvatarAvatar

>