06-21-2013, 01:39 PM
Tim: did you recap the RF deck on your 38-116??
How many Philco 38-116 radios are out there?
06-21-2013, 01:39 PM
Tim: did you recap the RF deck on your 38-116??
06-21-2013, 04:01 PM
If you didn't an easy way to do it is to remove the bandwitch shaft it is held in by 2 screw on the front unsolder the grounds of metal shields and remove the screw that holds them in then you can move them around to get at the caps.
06-21-2013, 07:59 PM
Tim, What are you saying? Should I try swaping out the 6A8G tube? If that is what you think would make the radio tune better I will give it a try... I will try to locate one.
06-21-2013, 08:11 PM
Or you can use 6D8. As long as the filaments are in parallel to each other.
06-28-2013, 07:32 AM
I have one--works and looks great. My favorite Philco in my collection. Ken
06-28-2013, 11:54 AM
Picked one up last summer from a barn.
Looks great and complete. Still on my to-do list
06-28-2013, 01:14 PM
I did remove the RF deck and recapped it; I also had to clear a short on the RF section of the bandswitch.
John, does your radio go dead on the low end of the BC band? A weak 6A8 can cause that problem. Tim KA3JRT
06-28-2013, 05:38 PM
Tim...Yes it does.....I guess I have to change out that tube and work from there. I really should invest in a tube tester. Where do you guys go to buy replacement tubes?
06-28-2013, 05:55 PM
When I need tubes, I always go to Bob Dobush at Findatube.com:
http://www.findatube.com/ Bob is one of the best guys in this hobby, and he offers good service and some of the best prices around. -- Ron Ramirez Ferdinand IN
07-02-2013, 07:39 AM
+1. Bob has always done me right.
07-04-2013, 01:03 PM
O.K. Thanks guys will go to his website to check it out!
« Next Oldest | Next Newest »
Users browsing this thread: 2 Guest(s) |
|