Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Anyone ever heard of a Philco Tropic 3214 Portable?
#1

Just got one from a radio meet--and it's pretty well beat up, but I can't find any info on it. I do know it was made for export.

It's a three way portable and it's cabinet is similar to the leather-covered 53-658. Except this one has two shortwave bands along with the AM band. Also has a telescopic SW antenna.

I found a pic somewhere on the net, so this is what it looks like.

Does anyone have access to a schematic on this one?

( Icon_lol Icon_lol Icon_lol This space reserved for gales of laughter stemming from unobtanium Icon_lol Icon_lol Icon_lol )

Bill
[Image: http://users.mw.net/~bmorris/3214.jpg]
#2

Hello Batterymaker. Have you checked with Dave Cantelon at: http://www.justradios.com in Canada? He has schematics for lots of export models. Nice Set!! Enjoy your Philco Tropic!! I have a Fada Tropic (bakelite), & love it!
#3

Hi Bill

I think I have the schematic for that set around here somewhere...no guarantees though. I believe it is in the 1953 Philco Home Radio Yearbook?

--
Ron Ramirez
Ferdinand IN
#4

Any chance you could dig in your yearbook, Ron? Just Radios turned up nada.
#5

Hey Bill,
You might try something like the discussion forum at http://www.vintage-radio.com in the UK. It seems sometimes they have the export model schematics that we don't.


-Bill M
#6

Got the schematic from someone on ARF. Unfortunately, it's water-damaged, but I'm trying to clean the image up. Did restring the dial with the info, though, so that's a small success.... Icon_smile

Bill
#7

More good news. I went ahead and installed a round of tubes (it had been picked clean before I purchased it), hitched it onto a battery and it plays--weakly, but it does pass a signal. So, despite a couple of kludged repairs and electrical damage, the radio has promise.

Once that's tackled, I aim to have the leather re-done. Oughta be a stunner when it's all done.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3962 online users. [Complete List]
» 1 Member(s) | 3961 Guest(s)
Avatar

>