Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My first vintage TV!
#1

It's not a Philco, but I'm more than happy with it. It's a 1955 Zenith 19R22. I got it yesterday from someone on CL for only $30. Read the whole story here.


Attached Files Image(s)
   

Slave to an RCA Victor CTC-25
#2

dave
umm sorry don`t mean to be harsh,  did I miss something what story ?
just a plug to another sight telling you to get it ?

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#3

Congratulations and beware - it can quickly lead to collecting more TVs!
I found the link lead to an interesting read of how he ended up with the TV and opinions on it's worth and restorability.
#4

I'm obviously new to vintage TV's and I'll probably have few questions. What do you all know about deflection yokes? The one on my Zenith is messed up, and I don't know what to look for.


Attached Files Image(s)
   

Slave to an RCA Victor CTC-25
#5

That's very typical because the type of plastic they used for the yoke housing disintegrates over time. It's very likely fine electrically. The back part that has detached have two magnetic centering rings on it. I've seen guys use epoxy or silicone to glue it back on and just electrical tape to hold it in place.
#6

The picture tube was replaced at some point with a Raytheon 21AUP4A.

Slave to an RCA Victor CTC-25




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5309 online users. [Complete List]
» 2 Member(s) | 5307 Guest(s)
AvatarAvatar

>