1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Advice on electolytic and solid state
Eric T
Senior Member
****
Posts: 298
Threads: 22
Joined: May 2012
City: Chattanooga State, Province, Country: TN
#7

07-28-2014, 06:17 PM
Arran, you are right about the 42-380 using push-pull 41s in the audio output stage. The schematic shows their plate voltages at 190V -as you said- well below maximum voltage for the 6X5.
It's not how bad you mess up, it's how well you can recover.
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Advice on electolytic and solid state - by Eric T - 07-28-2014, 06:17 PM



Users browsing this thread:
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration