Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco bakelite blocks
#2

"Jumping" them is not a good idea. It still leaves the old bad part in the circuit, unless you are cutting all the internal leads to the terminals.

I recommend ALWAYS re-building. I assume you've seen this section on my site regarding the bakelite block rebuilding?

BAKELITE BLOCK RE-BUILDING
Easy Steps to Re-building


Messages In This Thread
philco bakelite blocks - by Chris Drumma - 12-04-2005, 02:40 PM
[No subject] - by Chuck Schwark - 12-04-2005, 02:54 PM
[No subject] - by Chris Drumma - 12-04-2005, 03:24 PM
[No subject] - by Ron Ramirez - 12-04-2005, 04:05 PM
[No subject] - by Poston Drake - 12-07-2005, 12:26 PM
[No subject] - by don'tdomelikethat - 12-07-2005, 06:15 PM
[No subject] - by Guest - 12-08-2005, 09:14 PM
[No subject] - by Ron Ramirez - 12-08-2005, 09:44 PM
[No subject] - by Chuck Schwark - 12-08-2005, 11:32 PM
[No subject] - by Ron Ramirez - 12-09-2005, 12:42 AM
[No subject] - by Poston Drake - 12-09-2005, 10:19 AM
[No subject] - by Ron Ramirez - 12-09-2005, 11:52 AM



Users browsing this thread: 1 Guest(s)