11-30-2015, 08:46 PM
Have been recapping and recarbing. Had to replace the 280 ohm wirewound resistor (#45) which showed obvious overheating. The case was bulging and cracked (as was the 70 ohm (#46)). Surprisingly it still measured 304 ohms in the circuit and 340 after getting it out...incredible. 
[Image: https://www.dropbox.com/s/8xbcc3d2yzu16u....jpg?raw=1]
Here's another section under construction.
[Image: https://www.dropbox.com/s/p35huctd26ecdq....jpg?raw=1]
[Image: https://www.dropbox.com/s/fub0pshk5nj6uj....jpg?raw=1]
Three of the 6 resistors are replacements and all the caps are stuffed. I lost all the printing on the one cap in the lower right as I was pulling the guts out. Here's the 70 ohm 1/2 watt replacement in the final stages of painting. I used the same steps as in the 39-25 posts.
[Image: https://www.dropbox.com/s/u34olqvh2ou8sm....jpg?raw=1]
[Image: https://www.dropbox.com/s/8xbcc3d2yzu16u....jpg?raw=1]
Here's another section under construction.
[Image: https://www.dropbox.com/s/p35huctd26ecdq....jpg?raw=1]
[Image: https://www.dropbox.com/s/fub0pshk5nj6uj....jpg?raw=1]
Three of the 6 resistors are replacements and all the caps are stuffed. I lost all the printing on the one cap in the lower right as I was pulling the guts out. Here's the 70 ohm 1/2 watt replacement in the final stages of painting. I used the same steps as in the 39-25 posts.
[Image: https://www.dropbox.com/s/u34olqvh2ou8sm....jpg?raw=1]
