|
Zenith K731
01-03-2016, 09:01 PM
Paul, I have a similar Z set the 12DT8 tube is a pain. I have had several NOS fail after maybe 50-100 hours went to using 12AT7, ECC81 which are current production. The BIG DIFFERENCE is pin 9 on the ECC81 is center tap to the heater, on 12DT8 pin 9 is internal shield to ground. One must remove the ground connection from pin 9 of the tube socket or kiss your new tube good bye in a flash.
« Next Oldest | Next Newest »
Messages In This Thread
Zenith K731 - by Paul Philco322 - 01-03-2016, 05:51 PM
RE: Zenith K731 - by Phlogiston - 01-03-2016, 06:32 PM
RE: Zenith K731 - by Radioroslyn - 01-03-2016, 06:53 PM
RE: Zenith K731 - by Paul Philco322 - 01-03-2016, 07:58 PM
RE: Zenith K731 - by David - 01-03-2016, 09:01 PM
RE: Zenith K731 - by John Bartley - 01-03-2016, 09:05 PM
RE: Zenith K731 - by titan1a - 01-03-2016, 10:43 PM
RE: Zenith K731 - by VntgRads - 01-04-2016, 01:48 AM
Users browsing this thread: 2 Guest(s) |
