|
Philco model 87
01-22-2017, 01:16 PM
Okay so what I did was disconnect the center tap wire of the controller off of the coil so I could isolate the coil and the volume control. There are only 2 connections on that coil that sit up inside the can. When I measure that it reads 3.2 ohms. If I measure the control with the volume up all the way up, from the wire I disconnected I get a measurement of 10.5k and that's only the controller.
« Next Oldest | Next Newest »
Messages In This Thread
Philco model 87 - by flatheadjr - 09-28-2016, 08:27 PM
RE: Philco model 87 - by flatheadjr - 01-11-2017, 08:24 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 03:40 PM
RE: Philco model 87 - by Radioroslyn - 01-21-2017, 06:44 PM
RE: Philco model 87 - by Mondial - 01-21-2017, 08:34 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 08:52 PM
RE: Philco model 87 - by Radioroslyn - 01-21-2017, 11:07 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 11:30 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 06:10 AM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 01:16 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 02:11 PM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 02:48 PM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 12:25 AM
RE: Philco model 87 - by flatheadjr - 01-23-2017, 12:37 AM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 12:11 PM
RE: Philco model 77 - by Radioroslyn - 09-29-2016, 09:29 AM
RE: Philco model 77 - by flatheadjr - 09-29-2016, 11:17 AM
RE: Philco model 77 - by Arran - 10-01-2016, 04:00 AM
RE: Philco model 77 - by flatheadjr - 10-08-2016, 05:22 PM
RE: Philco model 77 - by Radioroslyn - 10-08-2016, 07:05 PM
RE: Philco model 77 - by flatheadjr - 10-12-2016, 08:31 PM
RE: Philco model 77 - by Radioroslyn - 10-12-2016, 09:35 PM
RE: Philco model 77 - by Radioroslyn - 10-17-2016, 07:05 PM
RE: Philco model 77 - by flatheadjr - 01-04-2017, 10:08 PM
RE: Philco model 77 - by Radioroslyn - 01-05-2017, 09:30 AM
RE: Philco model 77 - by flatheadjr - 01-05-2017, 08:46 PM
RE: Philco model 77 - by Arran - 01-09-2017, 03:02 AM
RE: Philco model 77 - by Radioroslyn - 01-09-2017, 10:42 AM
RE: Philco model 77 - by flatheadjr - 01-10-2017, 11:03 PM
RE: Philco model 77 - by Ron Ramirez - 01-11-2017, 12:20 PM
RE: Philco model 77 - by Radioroslyn - 01-11-2017, 08:03 AM
Users browsing this thread: 2 Guest(s) |
