|
Canadian Philco 26TI knob repair
02-04-2017, 01:30 PM
Can't tell for sure if the holes in the knobs go through to the other side or not. In any event you should be able to fill it with car bondo and then sand your way to a better look. I do not think this will be hard to do as the basic structure of the knob is intact.
Good Luck, Don
« Next Oldest | Next Newest »
Messages In This Thread
Canadian Philco 26TI knob repair - by radeonut - 02-04-2017, 01:15 PM
RE: Canadian Philco 26TI knob repair - by Old Tube - 02-04-2017, 01:30 PM
RE: Canadian Philco 26TI knob repair - by radeonut - 02-04-2017, 01:41 PM
RE: Canadian Philco 26TI knob repair - by OldRestorer - 02-04-2017, 06:54 PM
RE: Canadian Philco 26TI knob repair - by klondike98 - 02-04-2017, 07:25 PM
RE: Canadian Philco 26TI knob repair - by Ron Ramirez - 02-05-2017, 08:50 AM
RE: Canadian Philco 26TI knob repair - by radeonut - 02-06-2017, 07:56 AM
RE: Canadian Philco 26TI knob repair - by Ron Ramirez - 02-06-2017, 08:41 AM
RE: Canadian Philco 26TI knob repair - by gregb - 02-06-2017, 10:01 AM
RE: Canadian Philco 26TI knob repair - by Ron Ramirez - 02-06-2017, 10:23 AM
RE: Canadian Philco 26TI knob repair - by radeonut - 02-06-2017, 01:04 PM
RE: Canadian Philco 26TI knob repair - by gregb - 02-06-2017, 02:20 PM
RE: Canadian Philco 26TI knob repair - by Arran - 02-16-2017, 07:20 PM
RE: Canadian Philco 26TI knob repair - by radeonut - 05-21-2017, 11:03 PM
RE: Canadian Philco 26TI knob repair - by klondike98 - 05-22-2017, 07:51 AM
Users browsing this thread: 1 Guest(s) |
