hello Ron , Morzh , Sam , and all fellows participating to read and help me 
I hope everybody had a good night ... , a little bit short for me !
So , hereafter are new informations and photos
The set of lamps is following one :
36E( Philco ), 44E ( Philco ), 36 ( Philco ) , 56 ( Crampion ), 39 ( JRC ) , 42 ( Tung - Sol ), 80 ( Philco )
The dial has two scale graduations, one for LW ( 15 to 30 ) and second for MW ( 55 to 150 ), x 10 kHZ ranges I guess .
back chasssi panel have three cords :
- one for " in " mains of the chassis ,
- one for " out " mains to the turntable
- one with 4 wires , I suppose to the pick up . but why four wires ???
- the socket four connections is to the associated outpout transformer located near the loud speakers
If it was possible to get the schematic of this export model ??? i' ll appreciate a lot
I hope everybody had a good night ... , a little bit short for me !
So , hereafter are new informations and photos
The set of lamps is following one :
36E( Philco ), 44E ( Philco ), 36 ( Philco ) , 56 ( Crampion ), 39 ( JRC ) , 42 ( Tung - Sol ), 80 ( Philco )
The dial has two scale graduations, one for LW ( 15 to 30 ) and second for MW ( 55 to 150 ), x 10 kHZ ranges I guess .
back chasssi panel have three cords :
- one for " in " mains of the chassis ,
- one for " out " mains to the turntable
- one with 4 wires , I suppose to the pick up . but why four wires ???
- the socket four connections is to the associated outpout transformer located near the loud speakers
If it was possible to get the schematic of this export model ??? i' ll appreciate a lot
