11-09-2017, 11:46 AM
The simple answer is to remove the felt or paper cap at the center of the spkr. You can carefully use an Exacto knife cut it out starting at the center and working your way outward. You don't want to cut into the vc or cone just the cap. It's just cemented along it's outside edge.
Personally I would just replace it w/a 4 or 5" square or round pm spkr. My understanding is that the 4x6 cones are difficult to find these days and sending one out to have it done is going to be 20-$30. Just my 2c.
GL
Personally I would just replace it w/a 4 or 5" square or round pm spkr. My understanding is that the 4x6 cones are difficult to find these days and sending one out to have it done is going to be 20-$30. Just my 2c.
GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
