|
Philco 42-390
08-05-2021, 01:07 PM
Looking for some clarity on the chassis hookup for antenna on this model. The cabinet has a cloth coated wire that runs the perimeter of the cabinet with a 4 pin hookup near the top back of the chassis , and the wave antenna has a 3 wire direct connection to the back of the chassis. Do they both have to be hooked up for reception.
Thanks for all your help. Rick
08-05-2021, 03:29 PM
Hi and welcome,
There are three wires that are part of the AM ant that connect to the copper loop. Those terminate at the 4 lug strip on the back of the chassis connections 2-4. #1 connects the the spkr and is used as a test point when performing an alignment. https://philcoradio.com/library/download...20Book.pdf Look @ pg 69 parts 4 and 3. When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
