1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Zenith 10S464 issue
murf
Senior Member
****
Posts: 663
Threads: 142
Joined: Jun 2011
City: Elko,MN.
#3

08-28-2022, 02:44 PM
Will take a look again.
I put a new 6K7 in there and always clean the tube pins and pin sockets.
Put a new wire and grid cap on the 6K7 also.
Did not do anything with the 6A8 grid cap.
Last resort, I will try to monitor voltages if the new tubes I ordered don't cure it.
Thanks,
murf
Find
« Next Oldest | Next Newest »


Messages In This Thread
Zenith 10S464 issue - by murf - 08-28-2022, 01:28 PM
RE: Zenith 10S464 issue - by RodB - 08-28-2022, 02:35 PM
RE: Zenith 10S464 issue - by murf - 08-28-2022, 02:44 PM
RE: Zenith 10S464 issue - by MrFixr55 - 08-28-2022, 05:54 PM
RE: Zenith 10S464 issue - by murf - 08-28-2022, 06:04 PM
RE: Zenith 10S464 issue - by murf - 08-30-2022, 12:09 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)