|
Testing Model 20 tubes - Hickok 539A
03-28-2011, 05:56 PM
I dug out my old Hickok 539A tube tester to check tubes on the Philco model 20 that I am restoring. There were settings for 80 rectifier, but no settings on the chart for 27's, 24's, or 71A's. Does anyone happen to have these settings available for this tester?
Thanx.
03-28-2011, 06:41 PM
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
03-29-2011, 01:54 PM
Thanks, Terry
Do you know if data from other models still match up to the 539A? The suppliment seemed to only contain addition to newer tubes. I did find "obsolete" data under the Model 752 and the setting titles seem to correspond. Thanks again Randy
03-29-2011, 05:14 PM
Not sure. You could drop Steve a note and see what he has to say.
Terry When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
03-30-2011, 12:37 PM
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
