02-10-2012, 04:34 PM
The parts for my 50-922 will hopefully arrive today and my teen-aged son and I will be re-capping/re-resistoring it tomorrow. As I was going through the schematics and diagrams, I seem to be missing a capacitor.
Here's the radio schematic from nostalgiaair: [Admin note: bad link removed. Good link below in thread.]
I cannot, for the life of me, find C9. It appears in the parts list and it appears on the schematic diagram. It does NOT appear on the parts diagram (on either the run 2 or run 3 version) and it likewise does NOT appear anywhere on the radio itself. It's just. not. there.
What do I do in this case? I can determine where it SHOULD be based on the schematic and put it in, but as I recently read, it worked once or it would be in a landfill somewhere. Should I stick to what is actually physically there, attached to the chassis or should I believe the schematic?
Thanks!
Here's the radio schematic from nostalgiaair: [Admin note: bad link removed. Good link below in thread.]
I cannot, for the life of me, find C9. It appears in the parts list and it appears on the schematic diagram. It does NOT appear on the parts diagram (on either the run 2 or run 3 version) and it likewise does NOT appear anywhere on the radio itself. It's just. not. there.
What do I do in this case? I can determine where it SHOULD be based on the schematic and put it in, but as I recently read, it worked once or it would be in a landfill somewhere. Should I stick to what is actually physically there, attached to the chassis or should I believe the schematic?
Thanks!
--
DeShawn Smith
Current Project: Philco 50-922
