Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Marconi 138
#1

  I just bought this Marconi model 138. I really like the rogers and Marconi consoles.. They have those large dials and this one has 14 dial lights. I have it recapped and it does have a very clear and nice sound.. The cabinet will have to wait until spring and it is going to need some extensive work on the top.
  I may bring it in and do the repairs on the top during the winter. All the knobs are there but the grill cloth is shot.


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Those Canadian sets are way cool!
#3

Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
#4

(10-10-2015, 08:46 AM)John Bartley Wrote:  Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
   Thanks  John. It looks better than it is ..
  You make it sound so simple.  All those light colored lines running from front to rear,on the top are lifted veneer. It should be relatively easy to repair, but it just takes time.
  It  Will be worked on this winter.
  Dan in Calgary

   Living in Calgary Alberta




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>