Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Marconi 138
#1

  I just bought this Marconi model 138. I really like the rogers and Marconi consoles.. They have those large dials and this one has 14 dial lights. I have it recapped and it does have a very clear and nice sound.. The cabinet will have to wait until spring and it is going to need some extensive work on the top.
  I may bring it in and do the repairs on the top during the winter. All the knobs are there but the grill cloth is shot.


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Those Canadian sets are way cool!
#3

Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
#4

(10-10-2015, 08:46 AM)John Bartley Wrote:  Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
   Thanks  John. It looks better than it is ..
  You make it sound so simple.  All those light colored lines running from front to rear,on the top are lifted veneer. It should be relatively easy to repair, but it just takes time.
  It  Will be worked on this winter.
  Dan in Calgary

   Living in Calgary Alberta




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 6164 online users. [Complete List]
» 2 Member(s) | 6162 Guest(s)
AvatarAvatar

>