Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-T702
#61

Yeah, the HV rectifier has been replaced. The HV is up where it should be about 5Kv. The picture is very viewable in a semi-dark room.

Crist
#62

Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

If I could find the place called "Somewhere", I could find "Anything" Icon_confused

Tim

Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
#63

(05-19-2016, 11:19 PM)Madmurdok Wrote:  Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

Yeah, I'm going to be patient.  Anybody have any knobs?

Crist
#64

 If you really can't stand watching a dim 7JP4 there are some scope tubes that will work as a cheap substitute, but the phosphors are P1 rather then P4, the drawback of course is that the phosphor is green rather then white. A lot of people go the scope tube route on one of those 3'' Pilot TVs since it's all too common to find one of the original 3KP4s with an open filament thanks to the goofy filament series string those sets used.
Regards
Arran
#65

Still looking for some knobs.

Crist




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 610B oscillator wiring
Thanks for the replies. It's not the really the hum that I am after. Just trying to understand why only the shortwave ba...Tubester — 04:01 PM
Restoring Philco 96
70 and 90 are Superhets, but at least the 2x45 model of 90 uses the Plate detector (and so does 70). Also the Atwaters,...morzh — 03:28 PM
Restoring Philco 96
Morzh, Prayers for your mom. I am sure that there was enough pain living through the Holocaust as a child. I pray dail...MrFixr55 — 02:19 PM
Philco 610B oscillator wiring
Hi Dan, Divide and conquer. First off trry to differentiate between 60Hz and 120 Hz hum. 120 Hz hum has a higher pit...MrFixr55 — 01:49 PM
Restoring Philco 96
Yes, other than takin a toll on your back, they are undeed way more repair friendly than many other Philcos. To me, som...morzh — 01:04 PM
Philco 610B oscillator wiring
If the wires look like they were this way from the factory (very neat and very dull soldering joints), I'd leave them be...morzh — 12:58 PM
My Philco 37-116 Restore
I managed to open up the Expander Unit and replace the grid cap wires. Tested the connections found they looked good and...dconant — 12:19 PM
610B Oscillator Questions
I've included a picture of the 'actual' schematic I created. I double checked several times and it appears to be accur...Tubester — 09:26 AM
First Radio restoration
Hi, welcome. I did a 40-130 a few years ago. I was very surprised at how well it performed. Just take care with that sp...Stan the Man — 07:20 AM
Restoring Philco 96
Situations of the like are not pleasant. Life is inevitable. Best of luck to you. I have two 76 chassis, in different ...Stan the Man — 07:12 AM

[-]
Who's Online
There are currently 1734 online users. [Complete List]
» 2 Member(s) | 1732 Guest(s)
AvatarAvatar

>