1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Fairbanks Morse model 56
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#16

02-23-2020, 01:59 AM
Don't think I've ever seen a metal standard based tube, only on the self centering tubes (octals). Pin 1 is always the heater. Have seen some tubes that have had a sprayed on coating but I don't remember if it has any connection to anything.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
Stall-U-Rated
Member
***
Posts: 165
Threads: 5
Joined: Jul 2017
City: Woodland, CA.
#17

02-23-2020, 02:06 AM
Hard to say... Both were 6A7G (glass ST types).. Wont know till i encounter another radio that uses the same tube and see how it behaves in that one...

Meanwhile, its a happy camper with the Philco brand (used) installed...

Steve
Find
Stall-U-Rated
Member
***
Posts: 165
Threads: 5
Joined: Jul 2017
City: Woodland, CA.
#18

02-27-2020, 12:01 AM
Found the old for sale ad on FB for this radio and gathered a couple before pics. And even one pic from the first power up...  And of all places to find the proper dial bulbs? A hardware store.. Ones that sell flashlight bulbs is a plus as well. And faucet washers made great tuner mount grommets.. Icon_e_wink

Steve


Attached Files Image(s)
           
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)