Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Philco 38-12 Cabinet Strip
#16

   
So...just figured I'd share what the radio looks like as I received it this week.  Certainly, there's a lot of cabinet work to do, and I'm a little concerned about what might be hidden under all that dark stain, lacquer, etc.  In addition, the dial is merely a photocopy of an actual dial, the pointer needle is incorrect, the knobs are incorrect, and the speaker fabric will likely need to be replaced.

Luckily, I was able to order a repro dial from Radio Daze, but am having trouble locating the correct pointer, knobs, and fabric.  I know this is probably elementary to most of you, so appreciate any recommendations on sources for these parts.
#17

The grille cloth is correct. It looks okay in the photo - is something wrong with it?

--
Ron Ramirez
Ferdinand IN
#18

Well, it is much dirtier than it appears in the photo, and won't match a fully restored cabinet very well, unless I can find a way to clean it carefully.  Parts of it are very delicate and will likely fall apart when I remove it anyway. Just want to have a decent backup if/when that occurs.

Finally located the correct knobs, so just hoping someone can recommend a source for the fabric and pointer...especially the pointer, as I'm learning that these are as scarce as hen's teeth!




Users browsing this thread:
[-]
Recent Posts
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, you refer to “AK”. Is that Alaska or Atwater-Kent, or… JoeJoe Rossi — 11:49 AM

[-]
Who's Online
There are currently 2298 online users. [Complete List]
» 1 Member(s) | 2297 Guest(s)
Avatar

>