Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco D-10 needle source
#16

Hi all
I think I have one of these needles. If you are still need it I will hunt for it. Let me know.
Joe

Joe Bratcher near Louisville, KY
#17

How much difference between the D-10 & D-10A needle??
Jim
#18

Jim
There is a lot of difference. The D-10 uses a crystal cart. The D-10A uses a dynamic cart. The needle I have is for a D-10A. The D-10 uses a needle that is easy to find whereas a needle for the D-10A is hard to find.
The needle I have is in post #14 in the green package
Joe

Joe Bratcher near Louisville, KY
#19

W4---much obliged for the info.
Jim
#20

I would be interested in the Needle if your willing to sell it. Let me know if interested. Thanks. Warren
#21

Warren

Yes it is for sale. I think I paid $21.00 for it. You can have it for what I paid, if you want it. Joe

Joe Bratcher near Louisville, KY
#22

Sounds fine . do you have paypal?
#23

PM sent
Joe

Joe Bratcher near Louisville, KY
#24

Picture of philco of philco magnetic cartridge and needle d10a
Icon_neutral




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3446 online users. [Complete List]
» 1 Member(s) | 3445 Guest(s)
Avatar

>