05-28-2020, 05:28 PM
Any way to bypass a missing shadow Meter on a philco 37-360?
It is the later version meter.
pn: 45-2189
TKS!
It is the later version meter.
pn: 45-2189
TKS!
|
Philco 37-630 Shadow Meter Bypass
05-28-2020, 06:05 PM
The coil is about 800-1000 ohms. The value isn't very critical.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
05-28-2020, 09:01 PM
It's a code 125.It looks like the radio should work without the meter in place.
I am correct?? TKS!!
05-28-2020, 09:39 PM
I didn't see a resistor across the meter in the diagram. You can check the screen grid voltage on the IF amp and the mixer. If it's very low you need the resistor.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
« Next Oldest | Next Newest »
Users browsing this thread: |
|
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
