Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

#1

Does anyone know if you can still get theses. And some of the color codes are gone . What do you look for to order replacements .
I seen the site at the repair bench . Does Chuck sell them. Icon_rolleyes
Thanks Kent.
#2

Hi Kent

No, Chuck does not sell them, but here's a few places that do:

Mouser Electronics - http://www.mouser.com/

Radio Daze - http://www.radiodaze.com/

Vacuum Tubes, Inc. - http://www.vacuumtubesinc.com/

Jim Cross, owner of Vacuum Tubes, Inc., is another of the "good guys" in the radio hobby and is deserving of our support.

Basically, you need to know the value of your original mica caps and then order new micas that are at or as close to the original value as possible.

I think most micas have a working voltage of 500 volts DC, which is plenty for nearly any radio application. Some are rated at 300 volts DC which is still enough for many radio circuits using mica caps.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
Would an output transformer if weak, cause the problems I am seeing with lower B+ voltage? murfmurf — 01:22 PM
Testing a speaker and output transformer Trutone A2-G
Hello murf! I merged the threads. Please do not start new threads regarding the same radio. Take care, - GaryGarySP — 10:21 PM
Philco 42-345 Restoration/Repair
Regarding picture 5 on page 1 of this thread this capacitor is #40 on scematics diagram - 4mF+4mF. Black wire is "-...Vlad95 — 09:01 PM
Philco 42-345 Restoration/Repair
That's a dual 4 MFD, red and green are both 4mfd and black is common negative. You should be able to see them in the pow...RodB — 08:58 PM
Philco 42-345 Restoration/Repair
Can anyone help me figure out a capacitor that has 3 wires coming out of it red and green on one side and a black wire o...osanders0311 — 08:14 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Philco model 38 code 121 not receiving signal.
You should be able to inject an audio signal such as from a CD or mP3into the radio at the volume control. The set will...MrFixr55 — 08:14 PM

[-]
Who's Online
There are currently 537 online users. [Complete List]
» 1 Member(s) | 536 Guest(s)
Avatar

>